Photos are projected negative and upside down if you were to see the image exposed inside a camera. When made positive and flipped to the correct view you end up with a classic photo:
wut is dis
idunnocollegeartstuff
Friday, 17 December 2010
Photography Class: Taking Photos & Processing.
The basic idea of taking photos with the pinhole camera is to just lay it pointing at the subject you want the picture to be. Then opening the shutter (the cardboard door) and exposing light through onto the photographic paper. (Note: the tin is loaded with photographic paper beforehand, done in the dark room so the paper is not spoiled and exposed already).
The exposure time is based on the f-stop (the distance of the pinhole to paper divided by the diameter of the pinhole in mm).
A smaller f-stop has a quicker exposure time while a larger one a longer exposure. Initially I went with 90seconds of exposure time with a f-stop of 220mm which resulted the image to be processed as almost blank with a few shapes formed. Because of the distance of the pinhole to the camera I took another try exposing it for 2minutes and this time a vague image appeared:
With 2minutes the image was beginning to show and shapes were forming but I felt not clear enough so I went out again trying for 5minutes which resulted to this:
The exposure time is based on the f-stop (the distance of the pinhole to paper divided by the diameter of the pinhole in mm).
A smaller f-stop has a quicker exposure time while a larger one a longer exposure. Initially I went with 90seconds of exposure time with a f-stop of 220mm which resulted the image to be processed as almost blank with a few shapes formed. Because of the distance of the pinhole to the camera I took another try exposing it for 2minutes and this time a vague image appeared:
![]() |
| Exposed for 2minutes~ |
![]() |
| Exposed 5minutes~ |
At 5 minutes the exposure was too long, which resulted in the image almost going black. It wasn't complete black and you can see grey sillouettes of objects.
The next attempt I exposed it for 4minutes as I felt I almost had it with 5 minutes but it was just maybe 1 minute too long. The result:
![]() |
| At 4 minutes~ |
After 4 attempts I finally achieved a still rough but clear image where you can see clearly the subjects and objects.
I then decided to go for some experiemental pictures. The first set was strips of photo paper stuck curved inside the tin on the side. The next few images I decided to go for a bigger piece of paper curved in all directions ( both vertically and horizontal). For an subject I wanted to capture trees.
Again I had to experiment with timings in exposure, the first being around 3minutes, then 4minutes and the final one just over 5minutes.
In the images you can almost see where the paper was curved vertically and creates to distinct contrast in tones from one side to another.
I tended to try and capture the shapes of trees, in the end the images looks like fireworks.
How I process the images
Carefully unloading the paper from the tin in the dark room you put the paper into the following liquids:
- Developer - for about 2minutes to expose the picture
- Stop (water) - for about 30minutes to stop exposures from further exposing
- Fix - for about 5minutes to literally fix the image in place.
- Wash (water) - clean the photo from development liquids.
After all that is done place it through a laminating machine which instantly dries off any water particles on the paper and ready to display.
Photography Class: The Project.
The project assigned was to learn about photographic techniques. In this workshop we was introduced to the pinhole camera, one of the earliest and simpliest way of capturing images.
Example of images done by pinhole cameras from http://www.pinhole.org/
Images taken from a pinhole camera are usually unique and difficult to reproduce directly again. Reasons being that the pinhole camera is a very raw device, the components controls and mechanism are control and made by hand and without a lens the focus of the image is difficult if not impossible to control. Many artists today still use a pinhole camera because of the uniqueness of the images you gain from them.
Making a Pinhole Camera:
Example of images done by pinhole cameras from http://www.pinhole.org/
![]() |
| Tom McCutcheon |
![]() |
| Scott Petty |
![]() |
| Justin Quinell |
Making a Pinhole Camera:
We were asked to bring in a tin or box that can be sealed so light cannot go through cept through a pinhole. I chose a Cadbury's chocolate tin box.
The steps of making the camera follows:
- Paint the inside of the tin black, including the lid so no light can reflect and interfere when taking a image. Give one layer of black paint, wait to dry and give another coating to make sure, re-apply more paint if do not feel it's covered enough
- Create a small hole on the tin, acting as a lens' barrel.
- Cut a flat piece of foil (make sure its flat with little creases) and apply ontop of the hold and seal it into place using gaffer tape.
- Create a fine hole using a pin, smaller the better as it will affect exposure times.
- Using cardboard cut a piece large enough to cover the pinhole and tape it on so it functions as a door.
And that's how I made my pinhole camera!
Photography Class
An introduction to Photography:
Photography is the process of creating a still or moving pictures by recording radiation on a sensitive medium (example such as photographic paper/film and electronic sensors.
Light patterns is reflected or emitted from objects which activate sensitive chemicals or electronic sensors during a timed exposure (usually through a photographic lens found in many cameras). The information/image is stored chemically or electronically (digital).
Photography is used everywhere, whether it's business, science, art, leisure or as a hobbie. There is always a need to record visually, and photography is essentially the easiest way to do it.
Photography is the process of creating a still or moving pictures by recording radiation on a sensitive medium (example such as photographic paper/film and electronic sensors.
Light patterns is reflected or emitted from objects which activate sensitive chemicals or electronic sensors during a timed exposure (usually through a photographic lens found in many cameras). The information/image is stored chemically or electronically (digital).
Photography is used everywhere, whether it's business, science, art, leisure or as a hobbie. There is always a need to record visually, and photography is essentially the easiest way to do it.
The main device used to capture images in photography is a camera, the name itself comes from the camaera obscura, an early mechanism of projecting images on walls and where an entire room functioned as a imaging system.
The general idea of taking photographs is
capturing light, by manipulating and controlling how light flows in both speed and size to create different effects in the final image. The key components of a camera is the shutter, aperture and lens.
The shutter is the component that allows light through to a camera, basically a door but only opening for a determined period of time. The faster the shutter speed (the faster it opens and closes) the more of a still image you will get and less motion blur.
The Aperature is the hole behind the shutter which should be the only area that light is passing through into the camera. The unit measurement of this process is called a f-stop. A low value f-stop would mean a larger hole and a higher value would mean a smaller hole.
The lens of a camera captures the light and brings it into focus from the subject into the camera itself. A lens can determine how big the area of the subject is captured.
![]() |
| A 17th Century drawing of a camera obscura in Italy. |
capturing light, by manipulating and controlling how light flows in both speed and size to create different effects in the final image. The key components of a camera is the shutter, aperture and lens.
The shutter is the component that allows light through to a camera, basically a door but only opening for a determined period of time. The faster the shutter speed (the faster it opens and closes) the more of a still image you will get and less motion blur.
![]() |
| Example of aperature sizes (f-stops) |
The lens of a camera captures the light and brings it into focus from the subject into the camera itself. A lens can determine how big the area of the subject is captured.
Subscribe to:
Posts (Atom)
















