Friday, 17 December 2010

Photography Class: Taking Photos & Processing.

The basic idea of taking photos with the pinhole camera is to just lay it pointing at the subject you want the picture to be. Then opening the shutter (the cardboard door) and exposing light through onto the photographic paper. (Note: the tin is loaded with photographic paper beforehand, done in the dark room so the paper is not spoiled and exposed already).

The exposure time is based on the f-stop (the distance of the pinhole to paper divided by the diameter of the pinhole in mm).

A smaller f-stop has a quicker exposure time while a larger one a longer exposure. Initially I went with 90seconds of exposure time with a f-stop of 220mm which resulted the image to be processed as almost blank with a few shapes formed. Because of the distance of the pinhole to the camera I took another try exposing it for 2minutes and this time a vague image appeared:


Exposed for 2minutes~

With 2minutes the image was beginning to show and shapes were forming but I felt not clear enough so I went out again trying for 5minutes which resulted to this:

Exposed 5minutes~
At 5 minutes the exposure was too long, which resulted in the image almost going black. It wasn't complete black and you can see grey sillouettes of objects.

The next attempt I exposed it for 4minutes as I felt I almost had it with 5 minutes but it was just maybe 1 minute too long. The result:

At 4 minutes~
After 4 attempts I finally achieved a still rough but clear image where you can see clearly the subjects and objects.

I then decided to go for some experiemental pictures. The first set was strips of photo paper stuck curved inside the tin on the side. The next few images I decided to go for a bigger piece of paper curved in all directions ( both vertically and horizontal). For an subject I wanted to capture trees.





Again I had to experiment with timings in exposure, the first being around 3minutes, then 4minutes and the final one just over 5minutes.

In the images you can almost see where the paper was curved vertically and creates to distinct contrast in tones from one side to another.

I tended to try and capture the shapes of trees, in the end the images looks like fireworks.

How I process the images

Carefully unloading the paper from the tin in the dark room you put the paper into the following liquids:

  • Developer - for about 2minutes to expose the picture
  • Stop (water) - for about 30minutes to stop exposures from further exposing
  • Fix - for about 5minutes to literally fix the image in place.
  • Wash (water) - clean the photo from development liquids.
After all that is done place it through a laminating machine which instantly dries off any water particles on the paper and ready to display.

No comments:

Post a Comment